Silicone Coated Mylar

 

About Silicone Coated Mylar

The information presented below is believed accurate and is not intended to constitute a specification. The values given reflect average material characteristics and may vary slightly between base suppliers. Users should evaluate the material to determine the suitability for their own particular application.

Specifications

Product Code
G10JRM (previously known as S1P-75 or C1S-OUT)
Base Film
Polyethylene Terephthalate
First Run
Yes
Backside Coating
None
Default Coating Side
Outside
Property
Typical Value
Control Limit
Caliper (mils)
3
+/- 0.00025
Yield (in.2 / lb.)
6724
+/- 832
Release (grams) *
13 **
+/- 5

* Typical values are measured in grams per 1" at a peel speed of 90"/minute, 180 degrees, 1" strips, fresh, indicated ranges based on three different adhesives.

** Release levels measured using 3M 610 tape test.

 

P.O. Box 296
Morrisville, PA 19067, USA
Phone: 215-493-2008

Contact Us: